Gator Wall Mount Guitar Hanger, Maple Fretted Accessories

WALL PADDING
A black foam wall pad is included with the mounting plate to prevent scratching or marring of the wall or item the hanger is mounted to.

PERFECT CLEARANCE
The sleek black stand-off provides just the right amount of clearance from the wall for angled or straight head-stocks while maintaining a low profile appearance.

NECK CRADLE
The rubberized swivel yoke cradles the neck of the instrument and adjusts automatically based on shape of the neck, head-stock and weight to create the perfect presentation and keep the instrument straight.

Wood grain may vary from listing photos.

D E T A I L S

• Fits Electric Guitars, Acoustic Guitars, and Bass Guitars
  
• Rubberized Swivel Yoke to Properly Cradle Guitar Neck
  
• Sleek Black Standoff Provides Clearance for Both Straight and Angled Headstocks
  
• Cherry Finish Decorative Wall Plate Hides Mounting Hardware for Clean and Stylish Look
  
• Foam Wall Pad Prevents Surface Scratches or Marring
  
• Includes Mounting Screws and Drywall Anchors
  
• Safe for standard polyurethane finishes, not recommended for vintage/lacquer finishes

DIMENSIONS:

• Ext Width: 3.75″
  
• Ext Height: 2.5″
  
• Weight: 0.4lbs
  

INSTALLATION INSTRUCTIONS:

• Choose the desired location for guitar hanger to be mounted. If mounting to a concrete or brick surface, please DO NOT use the enclosed hardware. Appropriate masonry screws can be purchased at your local hardware store. For best results use a level and mount guitar hanger to a stud.
  
• Use inclosed foam pad as a template to mark the location of screw holes. Drill pilot holes where necessary, if a stud is not available, use included plastic drywall anchors.
• Attach foam pad to back of mounting plate and drive the supplied screws through the mounting plate into the stud or plastic drywall anchors using Phillips screwdriver.
• Place decorative cover over mounting plate (arrow on back of mounting plate indicates up)
• Place standoff onto decorative cover, endure logo on standoff is on left side. Finally, thread guitar hanger through standoff and onto mounting plate by rotating in a clockwise direction.

DO NOT OVER-TIGHTEN HANGER, IT SHOULD SLIGHTLY ROTATE IN BOTH DIRECTIONS WHEN INSTALLED CORRECTLY

DISCLAIMER: We are not responsible for the method in which the purchaser attaches this hanger to the wall, the strength of the wall material it is placed on, or any damage to instruments from falling. We recommend that the finish on the neck of the instrument be fully cured before resting it in any hanger.